Exam A QUESTION 1
Given the shown output, which statement is true regarding the router forwarding a packet to 192.168.32.1?
A. The packet will be forwarded to 10.1.1.1.
B. The packet will be forwarded to 10.1.1.2.
C. The packet will be forwarded to 10.1.1.3.
D. The packet will be forwarded to the default gateway.
E. None of the above — this is an invalid output.
Correct Answer: A
QUESTION 2
In the illustrated network, all routers are configured to run EIGRP on all links. R2 is configured to send a summary route only to R4, R5, and R6. If the link between R1 and R2 fails, what is the maximum number of queries R3 will receive for 192.168.1.0/24, given that all the packets transmitted during convergence are transmitted once (there are no dropped or retransmitted packets)? Will R4, R5, or R6 receive any queries?
A. R3 will receive one query for 192.168.1.0/24, from R2. R4, R5, and R6 will each receive, and reply to, one query each.
B. R3 will receive 4 queriesfor 192.168.1.0/24, one each from R2, R4, R5, and R6. R4, R5, and R6 will each receive, and reply to, one query each.
QUESTION 1
You have a Catalyst 6500 with a Supervisor IA with a MSFC. After a power outage, the MSFC has lost its boot image and now will only boot into ROMMON mode. You want to load a new image onto the Catalyst MSFC boot flash. What method can you use?
A. Console connection using Xmodem
B. FTP
C. TFTP
D. SNMP
E. SSH
Correct Answer: A
QUESTION 2
Which of the following statements regarding the use of SPAN on a Catalyst 6500 are true?
A. With SPAN an entire VLAN can be configured to be the source.
B. If the source port is configured as a trunk port, the traffic on the destination port will also be tagged, irrespective of the configuration on the destination port.
C. In any active SPAN session, the destination port will not participate in Spanning Tree.
Exam A
QUESTION 1
Into which two types of areas would an area border router (ABR) inject a default route? (Choose two.)
A. the autonomous system of a different interior gateway protocol (IGP)
B. area 0
C. totally stubby
D. NSSA
E. stub
F. the autonomous system of an exterior gateway protocol (EGP)
Correct Answer: CE
QUESTION 2
Refer to the exhibit. If VLAN 21 does not exist before typing the commands, what is the result of the
configuration applied on switch SW1?
A. A new VLAN 21 is created and port 0/8 is assigned to that VLAN.
Exam A
QUESTION 1
Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Correct Answer: C
QUESTION 2
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree Protocol IEEE 802.1D? (Choose two.)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Correct Answer: BD
QUESTION 3
If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
100% Valid Download From Flydumps Latest Cisco 350-001 Pdf Exam Free Practice Test Ensure You 100% Pass From Flydumps
Exam A QUESTION 1
Given the shown output, which statement is true regarding the router forwarding a packet to 192.168.32.1?
A. The packet will be forwarded to 10.1.1.1.
B. The packet will be forwarded to 10.1.1.2.
C. The packet will be forwarded to 10.1.1.3.
D. The packet will be forwarded to the default gateway.
E. None of the above — this is an invalid output.
Correct Answer: A
QUESTION 2
In the illustrated network, all routers are configured to run EIGRP on all links. R2 is configured to send a summary route only to R4, R5, and R6. If the link between R1 and R2 fails, what is the maximum number of queries R3 will receive for 192.168.1.0/24, given that all the packets transmitted during convergence are transmitted once (there are no dropped or retransmitted packets)? Will R4, R5, or R6 receive any queries?
A. R3 will receive one query for 192.168.1.0/24, from R2. R4, R5, and R6 will each receive, and reply to, one query each.
Read MoreB. R3 will receive 4 queriesfor 192.168.1.0/24, one each from R2, R4, R5, and R6. R4, R5, and R6 will each receive, and reply to, one query each.
Cisco 350-001 test: High Pass RateCisco 350-001 Flydumps With All New Exam Questions
QUESTION 1
Read MoreYou have a Catalyst 6500 with a Supervisor IA with a MSFC. After a power outage, the MSFC has lost its boot image and now will only boot into ROMMON mode. You want to load a new image onto the Catalyst MSFC boot flash. What method can you use?
A. Console connection using Xmodem
B. FTP
C. TFTP
D. SNMP
E. SSH
Correct Answer: A
QUESTION 2
Which of the following statements regarding the use of SPAN on a Catalyst 6500 are true?
A. With SPAN an entire VLAN can be configured to be the source.
B. If the source port is configured as a trunk port, the traffic on the destination port will also be tagged, irrespective of the configuration on the destination port.
C. In any active SPAN session, the destination port will not participate in Spanning Tree.
PDF Cisco 350-001 – Download Certification Of Latest Version 100-101 To Ensure You 100% Pass From Flydumps
Exam A
QUESTION 1
Into which two types of areas would an area border router (ABR) inject a default route? (Choose two.)
A. the autonomous system of a different interior gateway protocol (IGP)
B. area 0
C. totally stubby
D. NSSA
E. stub
F. the autonomous system of an exterior gateway protocol (EGP)
Correct Answer: CE
QUESTION 2
Refer to the exhibit. If VLAN 21 does not exist before typing the commands, what is the result of the
configuration applied on switch SW1?
A. A new VLAN 21 is created and port 0/8 is assigned to that VLAN.
Read MoreRecent Updated New Cisco 350-001 Dumps with Exam Practice Questions
Exam A
QUESTION 1
Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Correct Answer: C
QUESTION 2
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree Protocol IEEE 802.1D? (Choose two.)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Correct Answer: BD
Read MoreQUESTION 3
If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?